10 Hot SSD Implementations

Enterprise Storage Forum content and product recommendations are editorially independent. We may make money when you click on links to our partners. Learn More.

Solid State Drives (SSD) continue to be super-hot, as the aisles of Storage Networking World (SNW) demonstrated earlier this month. It seemed that half the vendors were touting their latest flash products.

And the flames are being fanned by steadily falling prices –- about 50 percent per year. That has some forecasting the end of the hard disk. But Jim Handy, an SSD analyst for Objective Analysis said that is never going to happen. SSD prices may be dropping rapidly, but hard drive prices are falling just as fast.

“It’s like the old cowboy gag about the gunslinger saying, ‘stand still so I can shoot you’,” said Handy. “Both SSD and hard disk drives (HDD) are on a trajectory per GB to drop at 50 percent per year.”

Nevertheless, there are plenty of compelling reasons to adopt SSDs. Here are some of the innovative applications of this technology discovered at SNW.

1. Virident

Virident has a PCIe-based SSD offering similar to FusionIO. The differentiators, though, are sustained performance and replaceable flash modules. It is known as Virident tachIOn PCIe SSD, and it is available in cards with 300, 400, 600 and 800 GB. “You can replace our flash modules without having to replace the card,” said Jon Murphy, VP Channels. “In addition, most other approaches to SSD can’t sustain performance over time under load.”

Virident stabilizes high SSD performance courtesy of its two-controller architecture. Moving forward, Murphy expects PCIe deployments to dominate over the traditional HDD form factor for SSD. Reason: Having data near to the application CPU gives you far higher compute rates compared to using SAS/SATA-connected technologies that are employed when you plug the SSD into a hard drive slot.

2. Viking

Viking Modular Solutions offers high-capacity SSD for enterprise storage and server applications. Known as SATADIMM, it provides 60,000 IOPS, 6 Gb/sec SATA performance (is SAS compatible), has a 75 percent smaller footprint than traditional SSD (which uses a 2.5 inch HDD form factor), and it plugs into the DDR3 DIMM sockets used in memory.

“Why stick with the traditional SSD form factors when you gain so much by plugging it into DIMM sockets,” said Jonathan Hinkle, memory systems architect at Viking. “Instead of replacing cheap drives with SSD and thereby lowering storage capacity, keep the SATA disks in place and utilize spare DIMM sockets for flash.”

Systems that currently use massive amounts of RAM, for example, could replace some memory with a few TB of flash and be able to provide high performance for a much higher data set, he added. SATADIMM is available in sizes of up to 480 GB.

3. StorSimple

StorSimple 5000 and 7000 hybrid cloud appliances include an SSD top tier. The company augments this by deduplicating data in the background once it is written to SSD. That reduces the amount of data that must be sent across the WAN to the associated cloud services provider such as Amazon, EMC Atmos, AT&T, Zetta or Microsoft.

“We duplicate within a separate layer within the SSD so it doesn’t interfere with any ongoing writes,” said Ian Howells, chief marketing officer of StorSimple. “90 percent of active data can be read from within an SSD.”

4. Smart

SMART Modular Technologies‘ XceedIOPS2 SATA 1.8″ and 2.5″ SSDs are equipped with the SandForce SF-2000 series SSD processor as well as a 6Gb/s SATA interface. This delivers 60K IOPS and sequential performance of 520MB/s, as well as encryption. It is available in densities from 50 GB to 400 GB.

One key thing to understand about SSD is the subject of endurance levels as measured in program/erase (P/E) cycles — i.e. how many times can you write, then erase and rewrite on a flash cell? This is important in comprehending the various types of cell technology used. There is single-level cell (SLC) and multi-level cell (MLC). While vendor estimates and counting methodologies vary, Mike Lakowicz, director of storage at SMART, said MLC typically offers up to 3000 P/E cycles, whereas SLC gives as much as 50,000 to 100,000 cycles. MLC Flash devices provide greater storage capacity, while SLC Flash provides faster write performance and greater reliability. Thus, many of the first wave of enterprise SSDs used SLC.

But various vendors, including SMART, have been working on enterprise-grade multilevel cell (E-MLC) technology, which Lakowicz said offers 30,000 P/E cycles. With SLC costing around $10 per GB, MLC at $2 to $3 and E-MLC at $4 to $5, he said that the company’s E-MLC products provide high reliability and performance comparable to SLC. He confessed, though, that it wasn’t perfect for all uses cases.

“If you are doing 100 percent writers all the time, use SLC,” said Lakowicz.

IDC said it is seeing a trend away from SLC towards MLC. The analyst firm is predicting 170 percent average annual revenue growth for MLC-based enterprise SSDs during the next four years.

“Data center applications, cloud computing and servers are increasingly looking toward SSDs based on MLC flash to satisfy the demands of enterprise economically,” said Jeff Janukowicz, an analyst at IDC. “Enterprise SSDs using MLC flash with advanced performance and state-of-the-art controller technologies, include SMART’s new XceedIOPS2 SATA SSD.”

5. Micron

Micron Technology is another in the MLC camp. It offers SLC for some enterprise-class products, but it has just come out with a laptop device called the RealSSD C400 using MLC. Pricing for it should be not much more than $100 for a 64 GB version, which begins to make it very attractive for broad deployment. It has a couple of small form factors available (1.8 inch and 2.5 inch) in sizes from 64 GB to 512 GB, and it supports the SATA 6Gb/s interface, which opens up the data path between the host processor and the SSD.

6. Anobit

A different take on MLC is offered by Anobit. Pamela Oren of Anobit said the company takes consumer grad MLC and boosts its endurance up to 50,000 cycles and performance (over 24,000 IOPS) on its Genesis 1 Enterprise SSD. This is achieved by adding its Memory Signal Processing (MSP) into the mix. By eliminating a lot of error correction typically required in SSD, this provides the hike in endurance and performance. The product is delivered in 200 GB and 400 GB versions, which slide into standard hard drive slots.

“The MSP controller sits on the flash to provide a much better device for the same price,” said Oren.

7. Huawei Symantec

Huawei Symantec is a partnership between a Chinese firm and Symantec to deliver storage hardware to the market. The company’s Oceanspace Dorado2100 is an SSD box aimed at accelerating database queries, high-performance computing, financial applications and mass random file processing workloads. This 2U system provides 80,000 IOPS and 24 SSDs using SLC. Expect competitive pricing from an outfit that is keen to gain traction in the U.S. market.

8. Seagate

While the new kids on the block are getting all the headlines, Tom Coughlin, an analyst at Coughlin Associates, said he believes the old guard could well win out in the end. Seagate, for example, a veteran of the enterprise HDD space, has just released an MLC-based SSD.

“Seagate has decades of experience in integration hard drives into enterprise products,” said Coughlin. “They also have people on the ground that can deal with the lengthy qualification process. The startups can’t compete with that in the SSD space.”

9. Hitachi/Intel

Intel has had SSD products for a couple of years now. And Coughlin said the company had teamed up with Hitachi Global Storage Technology (which is the midst of being acquired by Western Digital) to create enterprise class SSD products. This assembles all the same factors as with Seagate, with the added clout of Intel.

10. Looking Ahead at Storage Class Memory

A couple of last week’s SNW speakers featured the next generation of solid state which holds the collective term of storage-class memory (SCM). A variety of technologies are under development in this class and it’s too early to say which will win out. IBM is one of the major players.

“SCM is 10,000x faster than a HDD and lies somewhere between RAM and Flash,” said Dr. Krishna Nathan, vice president of storage systems development at IBM. “SCM will have a bigger impact on storage than SSD and by 2020 when it should cost of $0.05 per GB.” Stay tuned for more details as prototypes and early products emerge.

Drew Robb is a freelance writer specializing in technology and engineering. Currently living in California, he is originally from Scotland, where he received a degree in geology and geography from the University of Strathclyde. He is the author of Server Disk Management in a Windows Environment (CRC Press).

Follow Enterprise Storage Forum on Twitter

Drew Robb
Drew Robb
Drew Robb is a contributing writer for Datamation, Enterprise Storage Forum, eSecurity Planet, Channel Insider, and eWeek. He has been reporting on all areas of IT for more than 25 years. He has a degree from the University of Strathclyde UK (USUK), and lives in the Tampa Bay area of Florida.

Get the Free Newsletter!

Subscribe to Cloud Insider for top news, trends, and analysis.

Latest Articles

15 Software Defined Storage Best Practices

Software Defined Storage (SDS) enables the use of commodity storage hardware. Learn 15 best practices for SDS implementation.

What is Fibre Channel over Ethernet (FCoE)?

Fibre Channel Over Ethernet (FCoE) is the encapsulation and transmission of Fibre Channel (FC) frames over enhanced Ethernet networks, combining the advantages of Ethernet...

9 Types of Computer Memory Defined (With Use Cases)

Computer memory is a term for all of the types of data storage technology that a computer may use. Learn more about the X types of computer memory.